Engine, Securing On Engine And Transmission Holder

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Lifting Tackle 3033
Engine And Transmission Holder VAS 6095
Shop Crane VAS 6100
Lift Arm Extension VAS 6101
Engine/Transmission Holder - V6 TDI Bracket VAS 6095/1-11

Procedure

Engine/transmission assembly removed and separated on Scissor Lift Table VAS 6131B.
Engine secured with Articulated Joint Support VAS 6131/13-7.

-- Attach the Lift Arm Extension VAS 6101 to the Shop Crane VAS 6100.

Fig 1: Identifying Engine Assembly Lift Tools

Courtesy of AUDI OF AMERICA, LLC

-- Engage the Lifting Tackle 3033 on the engine lifting eyes and on the shop crane as shown in the illustration.

-- Tension engine slightly with shop crane, do not raise.

Engine Mount Version 1

Fig 2: Locating Nut On Electrical Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the left and right connectors -2- for the Left Electrohydraulic Engine Mount Solenoid Valve -N144- /Right Electrohydraulic Engine Mount Solenoid Valve - N145- and remove them from the bracket.

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

NOTE:

The installation position with the engine installed is shown in the illustration.

Engine Mount Version 2

Fig 3: Identifying Connector & Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and remove the bracket with the wiring harness from the subframe.

NOTE:

The installation position with the engine installed is shown in the illustration.

Continuation for All Vehicles

Fig 4: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right bolt -2- from the engine mount.

NOTE:

Ignore item -1-.

-- Remove the Articulated Joint Support VAS 6131/13-7 from the engine.

Fig 5: Identifying Articulated Joint Support VAS 6131/13-7

Courtesy of AUDI OF AMERICA, LLC

-- Raise engine from engine carrier.

-- Remove the bolts -arrows- and the left engine support.

Fig 6: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the right engine support.

Fig 7: Removing Nut And Freeing Up Ground Wire

Courtesy of AUDI OF AMERICA, LLC

-- Secure the starter on the engine.

NOTE:

Ignore item -1-.

-- Secure the engine to the Engine And Transmission Holder VAS 6095 using the Engine/Transmission Holder - Universal Mounting VAS 6095/1 and Engine/Transmission Holder - V6 TDI Bracket VAS 6095/1-11 and tighten to 40 Nm, as illustrated.

Fig 8: Identifying Engine Stand Assembly

Courtesy of AUDI OF AMERICA, LLC