LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (4.0L - Engine Assembly - Engine Code(S): CEUC & CRDB) >> 10 Engine Assembly >> Subframe Mount >> Subframe Mount Sensor/Actuator >> Removing

Subframe Mount Sensor/Actuator: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front noise insulation, refer to FRONT NOISE INSULATION, REMOVING AND INSTALLING .

Subframe Mount Sensor 2 -G749- / Subframe Mount Actuator 2 -N514- (Left):

-- Remove the rear noise insulation, refer to REAR NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the front left wheel spoiler, refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI A7/S7 or FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI RS7 .

-- Audi RS6/RS7: Remove the nut -arrow- and free up the coolant line.

Fig 1: Identifying Coolant Ling & Bolt
GWWA10-11723Courtesy of AUDI OF AMERICA, LLC

-- Loosen bolt -2- and remove the bolts -1 and 3-.

Fig 2: Identifying Hose Clamps
GWWA19-11527Courtesy of AUDI OF AMERICA, LLC

-- Left lower coolant hose push aside.

NOTE:

Ignore the -arrows-.

Continued for Both Sides:

-- Disconnect the connector -1-.

NOTE:

The Socket T30T10405 is required for the left side of the vehicle.

-- Remove bolt -2-, and remove the sensor/subframe mount actuator.

Fig 3: Identifying Sensor/Subframe Mount Actuator & Bolt
GWWA10-11735Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals