LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (4.0L - Engine Assembly - Engine Code(S): CEUC & CRDB) >> 10 Engine Assembly >> Subframe Mount >> Subframe Mount Control Module -J391-, Removing And Installing >> Removing

Subframe Mount Control Module -J391-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the right front wheel housing liner rear section, refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

-- Release the retainers in direction of -arrow- and then remove the Subframe Mount Control Module -J391- item -1-.

Fig 1: Subframe Mount Control Module -J931- Component Location
GWWA10-11562Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals