Overview - Subframe Mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Engine Mount

Fig 1: Engine Mount Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 6 Nm
Subframe Mount Sensor and Subframe Mount Actuator
- Right: Subframe Mount Sensor 1 -G748- and Subframe Mount Actuator 1 -N513-
- Left: Subframe Mount Sensor 2 -G749- and Subframe Mount Actuator 2 -N514-
- Removing and installing, refer to SUBFRAME MOUNT SENSOR/ACTUATOR .
- After installing perform the basic setting of the subframe mount adjustment see Vehicle Diagnostic Tester
Engine Mount
- Removing and installing, refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- After installing perform the basic setting of the subframe mount adjustment see Vehicle Diagnostic Tester
Bolt
- 20 Nm
Engine Mount Bracket
Bolt
- 40 Nm
Engine Support
Bolt
- 90 Nm +90°
- Replacing
Subframe
Bolt
- 55 Nm

Subframe Mount Control Module -J931-

Fig 2: Identifying Subframe Mount Control Module -J931-

Courtesy of AUDI OF AMERICA, LLC

Bracket
Connector
Subframe Mount Control Module -J931-
- Removing and installing, refer to SUBFRAME MOUNT CONTROL MODULE -J391-, REMOVING AND INSTALLING .
- After replacing perform the basic setting of the subframe mount adjustment see Vehicle Diagnostic Tester

DSG Transmission Mount 0B5

Fig 3: Identifying DSG Transmission Mount 0B5 Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Tunnel Crossmember
- Removing and installing, refer to OVERVIEW - SUBFRAME MOUNT .
Stop
- For the transmission mount
Transmission Mount
- Removing and installing, refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Nut
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Transmission Support
- Removing and installing, refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Nut
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .

Automatic Transmission Mount 0BK

Fig 4: Identifying Automatic Transmission Mount 0BK Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Tunnel Crossmember
- Removing and Installing, refer to OVERVIEW - SUBFRAME MOUNT .
Stop
- For the transmission mount
Transmission Mount
- Removing and installing, refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Nut
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Transmission Support
- Removing and installing, refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .
Nut
- Tightening specification, refer to OVERVIEW - SUBFRAME MOUNT .