Right Engine Mount, Removing And Installing: Removing

-- Disconnect the ground cable from the battery terminal, refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Support the engine in its installed position, refer to ENGINE, SUPPORTING IN INSTALLED POSITION .

-- Remove the right front wheel, refer to WHEELS AND TIRES .

-- Remove the front left and right wheel housing liners, refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the left and right front wheel spoiler, refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI A7/S7 or FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI RS7 .

-- Remove the oil filter element.

-- Remove the nuts -arrows- and lower the stabilizer bar.

Fig 1: Identifying Stabilizer Bar Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and push the ground wire aside.

Fig 2: Bolts & Right Engine Support

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wire from the right engine support.

-- Remove the connector -arrow- from the mount, disconnect it, and then guide it through the subframe.

Fig 3: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

Audi S6/S7: 

Fig 4: Locating Nut On Electrical Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right nut -1- and remove the bracket with the wiring harness from the subframe.

Audi RS6/RS7: 

Fig 5: Identifying Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right bolt -arrow-, free up the bracket with the wiring harness.

Continuation for All Vehicles: 

Fig 6: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -2 and 3- and free up the wires.

-- Remove the left and right bolts -1-.

-- Remove the bolts -arrows-.

-- Lift the engine using the Engine Support Bridge - Spindle 10-222A/11 item -1- to dimension -a-.

• Dimension -a- = approximately 20 mm.

-- Remove the retaining plate for the engine mount and the right engine mount.

Fig 7: Identifying Special Tool - 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC