Engine, Securing On Engine And Transmission Holder

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Engine And Transmission Holder VAS 6095 with Engine/Transmission Holder - V8 Engine Bracket VAS 6095/1-13

Procedure

Fig 1: Identifying Nut And Clamps

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness.

-- Remove the nut -3- and free up the hose clamp.

-- Loosen the clamps -arrows- to remove the coolant hose from the upper left coolant pipe -2-.

-- Unclip the upper left coolant pipe from the mount -1-.

-- Remove the bolts -arrows- and remove the left engine support.

Fig 2: Bolts And Left Engine Support

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness.

Fig 3: Bolts & Right Engine Support

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and free up the ground wire.

-- Remove the bolts -arrows- and remove the right engine support -1-.

-- Secure the starter on the engine.

-- Attach the engine using the Engine/Transmission Holder - V8 Engine Bracket VAS 6095/1-13 to the Engine And Transmission Holder VAS 6095 and tighten to 55 Nm, as shown in the illustration.

Fig 4: Identifying Engine, Holder VAS 6095 And Bracket For V6 FSI Engine VAS 6095/1-5

Courtesy of AUDI OF AMERICA, LLC