Overview - Exhaust Temperature Control, Vehicles With A Turbocharger Without A SCR-System
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Pressure Pipe
- for the Differential Pressure Sensor -G505-
- 45 Nm
- Heated Oxygen Sensor -G39- with Oxygen Sensor Heater -Z19-
- Removing and installing, refer to HEATED OXYGEN SENSOR -G39-, REMOVING AND INSTALLING, VEHICLES WITH A TURBOCHARGER .
- Differential Pressure Sensor -G505-
- Removing and installing, refer to DIFFERENTIAL PRESSURE SENSOR -G505-, REMOVING AND INSTALLING .
- Exhaust Gas Temperature Sensor 4 -G648-
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 4 -G648-, INSTALLING AND REMOVING, VEHICLES WITH A TURBOCHARGER .
- Coat the thread with hot bolt paste
- 45 Nm
- Exhaust Gas Temperature Sensor 1 -G235-
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 1 -G235-, INSTALLING AND REMOVING, VEHICLES WITH A TURBOCHARGER .
- Coat the thread with hot bolt paste
- 45 Nm
- Exhaust Gas Temperature Sensor 3 -G495-
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495-, REMOVING AND INSTALLING, VEHICLES WITH A TURBOCHARGER .
- Coat the thread with hot bolt paste
- 45 Nm