Exhaust Gas Temperature Sensor 2/4 -G648- / -G649-, Removing And Installing, Vehicles With Two Turbochargers: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When working on the whole exhaust system:
- Follow the safety precautions when working on the exhaust system, refer to EXHAUST SYSTEM SAFETY PRECAUTIONS .
NOTE:
The removal of the Exhaust Gas Temperature Sensor 4 for Bank 2 -G649- is shown.
When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.
-- Loosen the center underbody cover to the exhaust system and push slightly downward, refer to UNDERBODY PANELS, REMOVING AND INSTALLING .
-- Remove the connector -1- from the bracket and disconnect it.
-- Remove the Bank 2 Exhaust Gas Temperature Sensor 4 -G649- -item 2-.