Exhaust Gas Temperature Sensor 2 -G448-, Installing And Removing, Vehicles With Two Turbochargers: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When working on the whole exhaust system:
- Follow the safety precautions when working on the exhaust system, refer to EXHAUST SYSTEM SAFETY PRECAUTIONS .
NOTE:
When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Remove the connector -5- from the bracket, disconnect it and free up the wire.
-- Remove the Exhaust Gas Temperature Sensor 2 -G448- -item 2-.