Exhaust Gas Temperature Sensor 2 -G448-, Installing And Removing, Vehicles With A Turbocharger: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When working on the whole exhaust system:
- Follow the safety precautions when working on the exhaust system, refer to EXHAUST SYSTEM SAFETY PRECAUTIONS .
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the electrical harness connector -5- from the Exhaust Gas Temperature Sensor 2 -G448-.
-- Free up the wire.
-- Remove the Exhaust Gas Temperature Sensor 2 -G448- -2- with a tool from the Diesel Engine Tool Set - 17 mm T10395A.