EGR Temperature Sensor -G98-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the Intake Flap Motor -V157-, refer to INTAKE FLAP MOTOR -V157-, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and then press the bracket -2- and the EGR Cooler Switch-Over Valve -N345- -1- to the side.

Fig 1: Locating Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -1- from the bracket, disconnect it and free up the wire.

Fig 2: Locating Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the EGR Temperature Sensor -G98- -2-.