EGR Motor -V338-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the intake manifold, refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Fig 1: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

Fig 2: Locating Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Pay attention to the installed position of the EGR motor --.

-- Remove the bolts -arrows-.

-- Free up the coolant line and the fuel line.

-- Press the coolant line and the fuel line back and then remove the EGR Motor -V338- from the EGR cooler.