Secondary Air Injection Pump Motor -V101-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front right wheel spoiler, refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING, AUDI A7/S7 .

-- Vehicles with parking heater: Loosen the clamp -arrow- and move the auxiliary heater tail pipe -1- toward the rear.

Fig 1: Auxiliary Heater Tail Pipe & Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right air intake grille from the bottom of the bumper cover, refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, AUDI A7/S7 FROM MY 2015 .

-- Disconnect the connector -4- from the Secondary Air Injection Pump Motor -V101-.

-- Press the release buttons and remove the secondary air hoses -1- and -2-.

-- Remove the nuts -3- and the secondary air pump.

Fig 2: Secondary Air Injection Pump Motor Component Location

Courtesy of AUDI OF AMERICA, LLC