Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

Coat the thread on the nut with hot bolt paste .

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts, refer to Figure.

-- Install the right catalytic converter, refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITH DSG TRANSMISSION .

-- Install the Heated Oxygen Sensor -G39-, refer to HEATED OXYGEN SENSOR -G39- /OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-, REMOVING AND INSTALLING .

-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING => Filling .