LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (3.0L - Exhaust System & Emission Controls - Engine Code(S): CGXB & CTUA) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Exhaust Manifold, Removing And Installing >> Left Exhaust Manifold, Removing And Installing >> Installing

Left Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal and self-locking nuts.

Coat the thread on the nut with hot bolt paste .

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts, refer to Figure.

-- Electrical connections and wiring routing, refer to appropriate SYSTEM WIRING DIAGRAMS information.

-- Install the left catalytic converter, refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITH DSG TRANSMISSION .

-- Install the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING, ACCESSORY RIBBED BELT .

scientia non olet · About LEMON Manuals