Right Catalytic Converter, Removing And Installing, Vehicles With DSG Transmission: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

-- Install the right secondary air injection combination valve, refer to RIGHT COMBINATION VALVE, REMOVING AND INSTALLING .

-- Install the Oxygen Sensor after Three Way Catalytic Converter -G130-, refer to HEATED OXYGEN SENSOR -G39- /OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-, REMOVING AND INSTALLING .

-- Install the right coolant pipe on the transmission, refer to RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING .

-- Install the Throttle Valve Control Module -J338-, refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead, refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .