Exhaust Pipes/Mufflers, Separating: Notes

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler
The separating point is marked by a depression around the circumference of the exhaust pipe.

Special tools and workshop equipment required

Chain Pipe Cutter VAS 6254

Procedure

Fig 1: Identifying Exhaust Pipe Separating Points

Courtesy of AUDI OF AMERICA, LLC

-- Separate the exhaust pipes at a right angle at the separating points -arrow- using a Chain Pipe Cutter VAS 6254.

-- When installing, position the clamping sleeves -arrows- on the center of the separating point

Fig 2: Identifying Clamping Sleeve Positions

Courtesy of AUDI OF AMERICA, LLC

-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.

Fig 3: Identifying Installed Position Of Rear Double Clamps

Courtesy of AUDI OF AMERICA, LLC

Installed position: Threaded connections point forward.

-- Install the exhaust system free of tension, refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .