Overview - Rear Heat Shield

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Heat Shield

Courtesy of AUDI OF AMERICA, LLC

Nut
- 2.1 Nm
- Quantity: 2
Heat Shield
- For the propshaft
- Removing and installing. Refer to PROPSHAFT HEAT SHIELD, REMOVING AND INSTALLING .
Bolt
- 55 Nm
- Quantity: 8
Crossbrace
- Removing and installing. Refer to TUNNEL BRIDGE, REMOVING AND INSTALLING .
Heat Shield
- For the back of the tunnel
- Removing and installing. Refer to HEAT SHIELD FOR REAR TUNNEL, REMOVING AND INSTALLING .
Nut
- 2.1 Nm
- Quantity: 4
Heat Shield
- For the rear muffler
- Removing and installing. Refer to REAR MUFFLER HEAT SHIELD, REMOVING AND INSTALLING .
Washer
Nut
- 2.1 Nm
Heat Shield
- For the center of the exhaust system
- Removing and installing. Refer to CENTER EXHAUST SYSTEM HEAT SHIELD, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to[For engine(s) CTUA,CEUC,CRDB,CGXB] Fuel Supply .
Bolt
- 20 Nm
- Vehicles with a center muffler tightening specification. Refer to[For engine(s) CEUC,CRDB] Exhaust System, Emission Controls [For engine(s) CTUA,CGXB] Exhaust System, Emission Controls [For engine(s) CPNB] Exhaust System, Emission Controls .