Overview - Front Heat Shield
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 2.1 Nm
- Quantity: 4
- Front Heat Shield
- For the center of the tunnel
- For vehicles with a TDI engine
- Removing and installing. Refer to HEAT SHIELD FOR FRONT CENTER TUNNEL, REMOVING AND INSTALLING, VEHICLES WITH TDI ENGINE .
- Spring Clip
- Quantity: 3
- Heat Shield
- For the longitudinal member
- Removing and installing on vehicles with a gasoline engine: left refer to LEFT LONGITUDINAL MEMBER HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH GASOLINE ENGINE , right refer to RIGHT LONGITUDINAL MEMBER HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH GASOLINE ENGINE
- Removing and installing on vehicles with a TDI engine: left refer to LEFT LONGITUDINAL MEMBER HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH TDI ENGINE , right refer to RIGHT LONGITUDINAL MEMBER HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH TDI ENGINE
- Lock Washer
- Nut
- 2.1 Nm
- Quantity: 4
- Heat Shield
- For the center of the tunnel
- For vehicles with a gasoline engine
- Removing and installing. Refer to HEAT SHIELD FOR CENTER TUNNEL, REMOVING AND INSTALLING, VEHICLES WITH GASOLINE ENGINE .
- Left Heat Shield
- For the top of the tunnel
- Removing and installing. Refer to HEAT SHIELD FOR LEFT UPPER TUNNEL, REMOVING AND INSTALLING .
- Lock Washer
- Left: 2 washers, right: 3 washers
- Right Heat Shield
- For the top of the tunnel
- Removing and installing. Refer to HEAT SHIELD FOR RIGHT UPPER TUNNEL, REMOVING AND INSTALLING .
- Lock Washer
- Quantity: 2
- Heat Shield
- For the plenum chamber bulkhead
- There are different versions.
- Audi RS7 vehicles with additional vacuum line covering
- Removing and installing in vehicles with a gasoline engine. Refer to PLENUM CHAMBER BULKHEAD HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH GASOLINE ENGINE .
- Removing and installing in vehicles with a TDI engine. Refer to PLENUM CHAMBER BULKHEAD HEAT SHIELD, REMOVING AND INSTALLING, VEHICLES WITH TDI ENGINE .
- Rear Heat Shield
- For the center of the tunnel
- For vehicles with a TDI engine
- Removing and installing. Refer to HEAT SHIELD FOR REAR CENTER TUNNEL, REMOVING AND INSTALLING, VEHICLES WITH TDI ENGINE .