Digital Compass, Calibrating
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
It is necessary to calibrate the digital compass if:
- The compass directions are not correct,
- The letter "C" instead of a direction will appear or the display will be blank.
- A new Automatic Dimming Interior Rearview Mirror -Y7- is installed.
The digital compass may also need to be calibrated if:
- the vehicle battery was reconnected after being disconnected for an extended period,
- a new audio system or audio system component was installed.
Digital Compass, Calibrating:
-- Turn on the ignition.
- The letter "C" must appear in the compass display -1-.
-- If the letter "C" does not appear, press button -2- for 9 to 12 seconds until the "C" appears in the compass display.
-- Drive in a circle two to three times at about 10 km/h (5 mph) until a direction is shown in the compass display.
-- The interior rearview mirror automatic dimming function is reactivated after the calibration is complete. Refer to AUTOMATIC DIMMING FUNCTION, SWITCHING ON AND OFF .