LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Maintenance Procedures) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Windshield Wiper Blades, Checking, End Position And Wear >> Rear Window Wiper Blades, Checking

Rear Window Wiper Blades, Checking

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Check for Damage

-- Switch on the ignition.

-- Activate the windshield washer system to check to see if the wiping pattern is clean.

Check for abnormalities with the wiper blade:

-- Check the wiper blade for tears and damage.

Check Park Position

-- Activate the "Rear wiper" and let the wiper arm to run to end position.

-- Turn off ignition.

-- Check whether blade point rests in with the following distance to lower edge of window.

Fig 1: Identifying Rear Window Wiper Arm, Adjusting
GWWA92-10187Courtesy of AUDI OF AMERICA, LLC
NOTE: Dimension gives distance of wiper blade point to lower edge of window.

-- Activate rear window wiper.

-- Check the wiper arm adjustment again.

-- If necessary: Install the windshield wiper arm. Refer to WINDSHIELD WIPER ARMS .