Removing the Ignition Coils from Cylinder Bank 2

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connector -1- from the Engine Coolant Level Warning Switch -F66- on the bottom of the coolant reservoir and then move the coolant reservoir to the side with the coolant hoses -arrows- still connected.

Fig 1: Connector & Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- from the coolant reservoir.

-- Remove the screws -arrows- and disconnect the connectors on the ignition coils.

Fig 2: CMP Sensor And Exhaust Camshaft Control Valve Cylinder Bank 2 (Left)

Courtesy of AUDI OF AMERICA, LLC

-- Move the wiring harness slightly down.

Continuation for both sides:

-- Remove the ignition coils using the Puller T40039 -arrow-.

Fig 3: Identifying Ignition Coil Puller T40039 Removing Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

-- Remove spark plugs with Spark Plug Wrench 3122B.