Removing the Ignition Coils from Cylinder Bank 1

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to 3.0 TFSI GASOLINE ENGINE .

-- Free up the fuel line -1- and the line -2- from the EVAP canister on the air filter housing and air duct pipe.

-- Remove the vacuum hose -3- from the connection on the air guide pipe.

-- Loosen the hose clamps -arrows- and remove the air guide pipe.

Fig 1: Identifying Clamps

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -arrows- and disconnect the connectors on the ignition coils.

Fig 2: Camshaft Position Sensor And Exhaust Camshaft Control Valve Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Move the wiring harness slightly down.