Bleed and Fill the Brake System
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the adapter -1- to the brake fluid reservoir.
-- Connect filler hose -2- on Brake Charger/Bleeder Unit VAS 5234 to adapter.
-- Adjust for the correct pressure on the Brake Charger/Bleeder Unit VAS 5234.
| - | - |
NOTE:
It is required to remove the wheels for specific tire combinations.
Depending on the vehicle equipment, the rear brakes or front wheel and rear wheel brakes may be bled without removing the tires using the Brake Bleeding Tool Set VAS 6564.
For RHD vehicles, begin with the front right.
The bleed hose must fit tightly over the bleed screw to prevent air from getting into the brake system.
The brake fluid level in the reservoir must be high enough so that air cannot get into the brake system.