Required Special Tools and Equipment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Suspension Block Set T10156.

Fig 1: Identifying Spring Blocks T10156/1
Courtesy of AUDI OF AMERICA, LLC

Perform the following:

-- Straighten the vehicle wheels.

-- Release the vehicle. Refer to RAISING VEHICLE .

Front Axle Suspension Blocks, Inserting:

NOTE: Suspension blocks for the front axle are different and are marked accord to vehicle side.

-- Insert suspension blocks -A- between wheel housing -1- and upper rear control arm -2-.

Fig 2: Identifying Spring Blocks, Wheel Housing, And Upper Rear Control Arm

Courtesy of AUDI OF AMERICA, LLC

-- Repeat the process for the opening on the opposite side.

Rear Axle Suspension Struts, Inserting:

-- Remove the wheels on the rear axle.

-- Insert suspension block -A- between longitudinal -1- and upper transverse link -2-.

Fig 3: Identifying Spring Blocks, Side Rail, And Upper Transverse Link

Courtesy of AUDI OF AMERICA, LLC

-- Repeat the process for the opening on the opposite side.

-- Reinstall the wheels. Refer to WHEEL BOLTS TIGHTENING SPECIFICATIONS .

-- Lower vehicle.