LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Maintenance Procedures) >> 03 Maintenance, Diagnosis >> General Information >> Suspension Blocks, Installing >> Notes

Suspension Blocks, Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If pressure is lost in the air suspension shock absorbers, the vehicle does not have sufficient ground clearance. The vehicle must not be moved in this condition.

Use suspension blocks when, for example, the vehicle must be driven on an auto transporter or onto the hoist. This increases the ground clearance.

WARNING:
  • The vehicle must not be driven when suspensions blocks are installed.
  • The vehicle can only be moved.
  • When moving steering wheel from center position, do not turn more than a half left or right.
  • After completing suspension block installation, inspect areas around front suspension strut mounts for possible body damage and repair if necessary.
  • The upper rear control arms on the front axle must be replaced before the vehicle can be driven again.
scientia non olet · About LEMON Manuals