Engine Coolant Temperature Sensor on Radiator Outlet -G83-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Coolant Reservoir Cap

Courtesy of AUDI OF AMERICA, LLC

Engine is cold.

-- Briefly open the coolant reservoir cap -arrow- to reduce the residual pressure in the coolant system.

-- Remove the front noise insulation, refer to Noise Insulation .

-- Remove the front left wheel spoiler, refer to WHEEL HOUSING LINER .

NOTE: Ignore item -1-.

-- Disconnect the connector -3-.

NOTE: Use a cloth to catch any leaking coolant.

-- Remove the clamp -2- and the Engine Coolant Temperature Sensor on Radiator Outlet -G83-.

Fig 2: Component Location Engine Coolant Temperature Sensor on Radiator -G83-

Courtesy of AUDI OF AMERICA, LLC