LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (4.0L - Cooling System - Engine Code(S): CEUC & CRDB) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Upper Rear Coolant Pipe, Removing And Installing >> Installing

Upper Rear Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the air guides with the screw-type clamps, refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .

-- Install the wires, refer to Description and Operation and => appropriate System Wiring Diagram Information.

-- Install the plenum chamber bulkhead, refer to Bulkhead .

NOTE: Do not reuse used coolant.

-- Fill the coolant, refer to Filling .

scientia non olet · About LEMON Manuals