Lower Front Coolant Lines, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front noise insulation, refer to Noise Insulation .

-- Remove the lower front right longitudinal member, refer to Lock Carrier .

-- Remove the front bumper cover end plate, refer to FRONT BUMPER Front Bumper .

-- Remove the nut -arrow- and free up the coolant line.

Fig 1: Identifying Nut

Courtesy of AUDI OF AMERICA, LLC

-- Place the Shop Crane - Drip Tray VAS 6208 under separating point.

-- Remove the clamp -1- and loosen hose clamp -3- to disconnect the coolant hose and drain the coolant.

-- Remove the bolt -4- and remove the supports from the coolant pump.

-- Loosen hose clamp -arrow-, remove the front and right coolant lines.

Fig 2: Identifying Clamp, Hose Clamp And Bolt

Courtesy of AUDI OF AMERICA, LLC