Turbocharger Control Module 1 -J724-, Removing And Installing, Vehicles With A Turbocharger: Notes

Special tools and workshop equipment required 

• Turbo E-Positioner Service Kit VAS6395 or Turbo E-Positioner Service Kit VAS6395A
• Turbo E-Positioner Service Kit - Bracket VAS6395/6

Removing

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Release the cover -3- and swivel it to the side -arrow-.

Fig 1: Identifying Cover, Positive Terminal And Ground Terminal

Courtesy of AUDI OF AMERICA, LLC

-- Connect the E-Box VAS6395A/1 to the positive terminal -2- and to the ground -1- using the Connection Cable VAS6395/2.

Procedure for Electronic Unit (E-Box) VAS6395A/1:

Fig 2: Identifying Electronic Unit (E-Box)

Courtesy of AUDI OF AMERICA, LLC

-- Select the software version using the ↑  -5- and ↓  -6- buttons.

-- Press the v  button -4- to confirm the software version.

Procedure for Electronic Unit (E-Box) VAS6395/1:

Fig 3: Identifying VAS 6395/1 Software Version

Courtesy of AUDI OF AMERICA, LLC

Check the software version of the Electronic Unit (E-Box) VAS6395/1:

If the correct software is loaded, the following will be displayed on the Electronic Unit (E-Box) VAS6395/1 (2 seconds after the voltage supply is connected):

1. > 1. START
2. 2. NEXT [>]