Engine Cover Temperature Sensor -G765-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Follow all the rules of cleanliness, refer to CLEAN WORKING CONDITIONS
.
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
WARNING:
Fire hazards and risk of damage for a faulty engine cover.
- The engine cover must be always be installed before the hood is closed.
- The engine may neither be started nor driven without an engine cover.
-- Remove the air duct hoses by loosening the hose clamps -2-.
-- Release the retainer -3- turn the air filter housing upper section -1- counter-clockwise in direction of -arrow B- and then remove it.
-- Disconnect the connector -1-.
-- Remove the bolt -2- and then remove the Engine Cover Temperature Sensor -G765-.