LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (4.0L - Turbocharger & Supercharger - Engine Code(S): CEUC & CRDB) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Installing

Charge Air Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If there are small impressions on the fins, refer to COOLER AND CONDENSER ASSEMBLY .

Replace the seal.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

All of the coolant must be changed if the radiator was replaced.

-- Check the coolant level, refer to COOLANT, DRAINING AND FILLING => Filling .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.
scientia non olet · About LEMON Manuals