Overview - Heater And A/C Unit Air Intake Housing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Foam Seal
- Replace if damaged
- Air Intake Duct
- With back pressure/fresh air and recirculation door
- Do not dismantle
- Removing and Installing, refer to AIR INTAKE DUCT, REMOVING AND INSTALLING .
- Connecting Element
- Between the Recirculation Door Motor -V113- and the recirculation door
- Do not dismantle
- Lightly coat the bearing area with lubricant.
- Recirculation Door Motor -V113-
- Removing and Installing, refer to RECIRCULATION DOOR MOTOR -V113-, REMOVING AND INSTALLING .
- Connecting Element
- Between the Airflow Door Motor -V71- and the back pressure/fresh air door.
- Do not dismantle
- Lightly coat the bearing area with lubricant.
- Airflow Door Motor -V71-
- Removing and Installing, refer to AIRFLOW DOOR MOTOR -V71-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification:
- For the adjustment motor: 1 Nm
- For the air intake duct: 1 Nm
- For the air intake manifold: 1 Nm
- Tightening specification:
- Acoustic Cover
- Bracket
- Air Intake Manifold
- Do not dismantle
- Removing and Installing, refer to AIR INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Foam Seal
- Replace if damaged
- Glued onto the air intake duct to seal the connection point between the air intake duct and the Air Conditioning (A/C) unit
- Attaching PointNOTE:
The air intake housing can be attached additionally with the bolts -7- as needed.
- Air Intake Manifold Retainer
- Between the upper and lower sectionNOTE:
If the retainer no longer holds, the upper and lower section of the air intake housing can be bolted to one another at the attaching points -12-.
- Between the upper and lower section
- Dust and Pollen Filter
- There are different versions.
- Notes on the version with activated charcoal element, refer to DUST AND POLLEN FILTER WITH ACTIVATED CHARCOAL FILTER ELEMENT INFORMATION .
- Follow the replacement intervals, refer to => Maintenance Tables.
- Removing and Installing, refer to DUST AND POLLEN FILTER, REMOVING AND INSTALLING .
- Dust and Pollen Filter Shaft CoverNOTE:
Depending on the version, the cover housing may contain foam strips attached to it (for insulation in the room between the cover -item 18- in Fig 1), refer to DUST AND POLLEN FILTER, REMOVING AND INSTALLING .
- Fresh Air Blower -V2-
- With Fresh Air Blower Control Module -J126-
- There are different versions.
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function
- Removing and Installing, refer to FRESH AIR BLOWER -V2- WITH FRESH AIR BLOWER CONTROL MODULE -J126-, REMOVING AND INSTALLING .
- Bolt
- 1 Nm
- Quantity: 3
- Cover
- Quick Release
- 0.5 Nm
- Quantity: 2