Condensation Water Drain, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Installation is done is reverse order, observe the following:
-- Insert the bracket -A- into the condensation water drain hose -B-.
- The bracket must sit evenly in the condensation water drain hose.
-- Insert the bracket and condensation water drain hose into the opening in the body -C- until it audibly engages.
- Position the condensation water drain correctly in the bracket and with pre-tension on the body.
-- If there is pretensioning is not enough, seal the area between the body and the bracket, for example with silicone adhesive.
NOTE:
Install the condensation water drain hose so that it is not twisted or crushed.
Make sure the carpet does not push up against the condensation water drain hose when installing.
If a condensation water drain hose fits too loose on the A/C unit connection, secure it with a clamp, for example, so that it cannot slide off. Hose clamps.