OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "3"
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Circlip with Rubber Disc
- Remove carefully using a small screwdriver or needle-nose pliers (especially note belt pulley when doing this).
- Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "3" .
- The rubber disc that is vulcanized on serves as noise insulation during low compressor output when engine is idling
- Drive Plate
- Tightening specification: 35 Nm
- Attached to the A/C compressor input shaft
- There are different versions.
- The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.
- Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "3" .
- Circlip
- Replace
- Install on correct side (flat side toward A/C compressor)
- Removing and installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "3" .
- Spacer
- Dimensions: 17.5 x 10 x 3 mm
- Rubber Elements
- Quantity: 6, install on proper side, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "3" .
- Decouples belt pulley from compressor driveshaft, damps vibrations and noise.
- For installation, lightly coat rubber elements, for example with tire mounting paste or a soap solution (as a lubricant)
- Belt Pulley
- The belt pulley is made of plastic and is sensitive to impact, therefore take special care when handling it.
- There are different versions.
- Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "3" .
- A/C Compressor
- Without A/C Clutch -N25-
- There are different versions depending on engine installed and the market.
- Clean the A/C compressor flange before installing the pulley.