OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "2"
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- Replacing
- Drive Plate
- There are different versions.
- Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "2" .
- The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.
- Circlip
- Replacing
- Install on the proper side - the flat side faces A/C compressor
- Belt Pulley
- There are different versions.
- Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "2" .
- The overload protection takes over when the rubber element on the belt pulley loosens because the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.NOTE:
Under certain conditions (for example, rough engine idle), rubber element of pulley can disengage without a malfunction existing at compressor or in refrigerant circuit.
- A/C Compressor
- Clean the A/C compressor driveshaft before setting the belt pulley on it