LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Heating, Ventilation & Air Conditioning (A/C Compressor & Actuators)) >> 87 Air Conditioning >> A/C Compressor >> Overview - Belt Pulley >> OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "1"

OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "1"

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: A/C Compressor Belt Pulley, Denso Version 3 Overview
GWWA87-10427Courtesy of AUDI OF AMERICA, LLC
  1. Sealing Cap
  2. Drive Plate
    • Replacing
    • Attached to the A/C compressor input shaft
      NOTE:

      The thread of the new drive plate has already been greased with a specific amount of a grease by the manufacturer.

    • There are different versions.
    • The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.
    • With rubber elements for decoupling belt pulley from A/C compressor input, dampens rations and noise.
    • Removing and Installing, refer to BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR "Denso " VERSION "1" .
    • 30 Nm
  3. Circlip
    • Replacing
    • Install on the proper side - the flat side faces A/C compressor
  4. Belt Pulley
  5. A/C Compressor
    • Clean the A/C compressor driveshaft before setting the belt pulley on it
scientia non olet · About LEMON Manuals