Drive Plate With Anti-Friction Bearing, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following:

NOTE:

Replace the circlip.

-- Clean the A/C compressor flange before installing the drive plate.

-- Install the drive plate on the A/C compressor flange.

The fitting must be possible without much force.

-- Insert the locking ring -A- on the proper side.

The side with beveled insertion edge -C- faces away from the A/C compressor - install flat side facing the A/C compressor.