Transmission Fluid Temperature Sensor 2 -G754-, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

The 7-speed DSG transmission 0B5 (S tronic) has an additional Transmission Fluid Temperature Sensor 2 -G754- to monitor the transmission fluid temperature of the wheel set on certain engine versions.

Component location: in place of the manual transmission fluid (MTF) drain plug

Courtesy of AUDI OF AMERICA, LLC

Transmission Installed:

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

CAUTION:

Danger Of Causing Damage To The Transmission.

Without any or with too little manual transmission fluid inside the transmission:

do not start the engine and
do not tow the vehicle

Transmission Removed:

The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .-

Transmission, Removed Or Installed:

-- Place the Used Oil Collection and Extraction Unit :SMN372500 under the transmission.

-- Disconnect the connector -2- from Transmission Fluid Temperature Sensor 2 -G754-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Protect the connector -2- and the contacts on Transmission Fluid Temperature Sensor 2 -G754- from transmission fluid. Clean the connectors immediately if they come in contact with transmission fluid (Manual Transmission Fluid). Transmission fluid can cause contact problems in the connector contacts.

-- Remove the Transmission Fluid Temperature Sensor 2 -G754- -1-.

-- Drain the transmission fluid (MTF).

Install In Reverse Order Of Removal. Note The Following:

Tightening Specification: Transmission Fluid Temperature Sensor 2 -G754- to transmission, 45 Nm

-- Attach the wiring harness to the transmission -arrows-.

-- Fill the transmission fluid (MTF). Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Clean the transmission and tunnel crossmember.