Overview - Center Differential Housing, Bolted Driveshaft: Notes
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Bolt
- Aluminum bolts
- Quantity 11
- Replacing
- Tightening specification and sequence. Refer to Tightening Specifications .
- Housing
- For the center differential
- Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING, BOLTED DRIVESHAFT
- Ball Bearing
- For the flange shaft
- Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING
- Spacer Sleeve
- Removing and installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Gear Carrier
- Installed position: The tab must fit into the opening in the transmission intermediate housing
- Spacer Sleeve
- Shim
- Ball Bearing
- for the center differential
- Center Differential
- Ball Bearing
- For the center differential
- Pressure Spring
- Shim
- Plate Spring
- Installed position: The side curved outward faces the shaft seal -17-
- Locking Ring
- For the flange shaft
- Removing and installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Bolt
- Steel bolts
- Quantity: 2
- Replacing
- Tightening specification and sequence. Refer to Tightening Specifications .
- Balance Weight
- Installed depending on the version
- Shaft Seal
- Rear Flange Shaft
- without vibration damper
- For allocation refer to the Parts information.
- Removing and installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Rear Flange Shaft
- With vibration damper
- For allocation refer to the Parts information.
- Removing and installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Bolt
- 20 Nm +90°
- Replacing