LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Differential System & Final Drive System (General Information - 7-Speed Dual Clutch - 0B5)) >> 39 - Final Drive, Differential >> Transmission Fluid >> Transmission Fluid, Draining And Filling >> Draining >> Vehicles With Transmission Fluid Temperature Sensor 2 -G754- -1- Instead Of A Transmission Fluid (MTF) Drain Plug:

Vehicles With Transmission Fluid Temperature Sensor 2 -G754- -1- Instead Of A Transmission Fluid (MTF) Drain Plug:

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
GWWA34-10870Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition.

NOTE:

The connector on the Transmission Fluid Temperature Sensor 2 -G754- can be disconnected only when the ignition is turned off. The transmission will switch to emergency mode if the ignition is on. The counter for the increased temperature will count up and a DTC memory entry will be stored in the Transmission Control Module -J217- after 10 minutes.

-- Disconnect the connector -2- from Transmission Fluid Temperature Sensor 2 -G754- and tie it up.

NOTE:

Protect the connector -2- and the contacts on Transmission Fluid Temperature Sensor 2 -G754- from transmission fluid. Clean the connectors immediately if they come in contact with transmission fluid (Manual Transmission Fluid). Transmission fluid can cause contact problems in the connector contacts.

-- Remove the Transmission Fluid Temperature Sensor 2 -G754- -1-.

-- Drain the transmission fluid (MTF).

-- Tighten the Transmission Fluid Temperature Sensor 2 -G754- -1- and connect the connector -2-.