Overview - Final Drive
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Replacing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Differential
- Bolt
- Tightening specification and sequence. Refer to OVERVIEW - FINAL DRIVE .
- Quantity 10
- Locking Ring
- Always replace
- Right Flange Shaft
- Shaft Seal
- For the right flange shaft
- Replacing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Front Final Drive Cover
- Removing and installing. Refer to FRONT FINAL DRIVE COVER O-RING, REMOVING AND INSTALLING .
- O-ring
- Always replace
- On the front final drive cover
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Spring Pin
- Selector Lever
- Shaft Seal
- For the selector shaft
- Refer to SELECTOR SHAFT SEAL, REPLACING
- Bolt
- Tightening specification. Refer to OVERVIEW - FINAL DRIVE .
- Quantity: 3
- Left Flange Shaft
- Removing and installing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Gear Carrier
- Attached to the left flange shaft with the bearing -20- and the circlip -21-
- Bearings
- For the left flange shaft
- Pressed on to the left flange shaft
- Locking Ring
- Always replace
- For the left flange shaft bearing
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .