Right Flange Shaft, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Remove the right front wheel.
-- Remove the right drive axle cover -1- inside the wheel housing.
-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- and the right heat shield -1-.
-- Remove the bolts -arrows- and then remove the heat shield from the right drive axle.
-- Remove the right drive axle from the transmission flange shaft and move it back.
-- Place the :SMN372500 under the transmission.
-- Install the :3368 into a threaded hole in the right flange shaft.
-- Position the :VW771 with the :VW771/13 on the :3368 and remove the flange shaft.