Right Flange Shaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Replace the circlip on the right flange shaft.

-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.

-- Fill the space between the sealing- and dust lip half way with sealing grease.

-- Drive in the right flange shaft using the : VW295 .

-- Check the transmission oil lever in the final drive and fill if necessary. Refer to TRANSMISSION FLUID LEVEL, CHECKING .