Overview - Center Differential
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .
Rules for cleanliness when working on the S tronic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Bolt
- Tightening specification. Refer to OVERVIEW - CENTER DIFFERENTIAL .
- Bolt
- Tightening specification. Refer to OVERVIEW - CENTER DIFFERENTIAL .
- Aluminum bolts
- Quantity 11
- Housing
- For the center differential
- Refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING
- Gear Carrier
- Installed position: The tab must fit into the cut-out in the transmission housing.
- Center Differential
- Pressure Spring
- Assembly Sleeve
- Does not have to be installed again
- Locking Ring
- For the transmission output shaft ball bearing with splines
- Removing and Installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Locking Ring
- For the transmission output shaft with splines
- Removing and Installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Ball Bearing
- For the transmission output shaft with splines
- Removing and Installing. Refer to REAR FLANGE SHAFT, SEAL AND BALL BEARING, REMOVING AND INSTALLING .
- Bolt
- Steel bolts
- Quantity: 2
- Balance Weight
- Installed depending on the version
- Shaft Seal
- Replacing. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING
- Dust Ring
- Always replace after removing
- Transmission Output Shaft with Splines without Vibration Damper
- Allocation.
- Removing and Installing. Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING, TRANSMISSION OUTPUT SHAFT WITH SPLINES WITHOUT VIBRATION DAMPER .
- Transmission Output Shaft with Splines and Vibration Damper
- Allocation.
- Removing and Installing. Refer to OVERVIEW - CENTER DIFFERENTIAL .
- Installing the vibration damper. Refer to OVERVIEW - CENTER DIFFERENTIAL .