Overview - Glow Plug System: Notes
WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Glow Plug
- 12 Nm
Cylinder Bank 1 (Right):
- Glow Plug 1 -Q10-, Glow Plug 2 -Q11-, Glow Plug 3 -Q12-
- Cylinder 2 Combustion Chamber Pressure Sensor -G678- may be installed in cylinder 2 depending on the exhaust gas standards. Refer to figure in Glow Plug without Combustion Chamber Pressure Sensor .
Cylinder Bank 2 (Left):
- Glow Plug 4 -Q13-, Glow Plug 5 -Q14-, Glow Plug 6 -Q15-
- Removing and installing. Refer to GLOW PLUG, REMOVING AND INSTALLING .
- 12 Nm
- Connector
- Bolt
- 9 Nm
- Camshaft Position Sensor -G40-
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- O-ring
- Always replace
- Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm