Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .

Vehicles With An S-Tronic Transmission 0B5:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- from the right coolant pipe on the transmission.

NOTE:

Ignore item -1-.

-- Remove bolts -arrows- and move the ATF cooler slightly to the side.

Courtesy of AUDI OF AMERICA, LLC

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolt -1- and the Engine Speed Sensor -G28-.