Steel Bolts: Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
WARNING: This page is about a different car, the 2016 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Tighten the bolts in seven stages in the sequence shown.
Steps 1 to 3:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | Attach the sealing flange with the seal to the cylinder block | |
| 2. | -1- | Tighten for the idler roller -Item 6- OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE |
| 3. | -2, 3, 4- | 9 Nm |
Steps 4 to 6:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 4. | Insert a temperature regulator for the engine oil cooler with the cover | |
| 5. | -10- | Install all the way in by hand. |
| 6. | -1 to 19- | 9 Nm |
Step 7:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 7. | -2, 3 and 4- | 9 Nm |