Overview - Charge Air System
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Charge Air Cooler Housing
- With air guides
- Removing and installing. Refer to CHARGE AIR COOLER HOUSING, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Seal
- Always replace
- Seal
- Always replace
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- After replacing, replace entire amount of coolant
- Bolt
- 3.2 Nm
- Seal
- Always replace
- For the charge air cooler
- Bolt
- Tightening specification -Item 13- OVERVIEW - THROTTLE VALVE CONTROL MODULE .
- Air Guide Hose
- To the air guide pipe at the turbocharger
- Bolt
- 9 Nm
- Turbocharger Recirculation Valve -N249-
- Removing and installing. Refer to Turbocharger Recirculating Valve -N249-, REMOVING AND INSTALLING .
- O-Ring
- Always replace
- O-Ring
- Always replace
- Charge Air Pressure Sensor -G31-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Air Guide
- Seal
- Always replace
- Bolt
- 9 Nm
- Air Guide
- Seal
- Always replace
- Air Guide Hose
- To the air guide pipe at the turbocharger
- O-Ring
- Always replace
- Turbocharger Recirculation Valve Bank 2 -N427-
- Removing and installing. Refer to Turbocharger Recirculation Valve Bank 2 -N427-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Always replace
- Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- Seal
- Always replace
- Adjusting Buffer
- For the charge air cooler
- Bolt
- 9 Nm
- Grommet
- Seal
- Always replace