LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Turbocharger System (Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler Housing, Removing And Installing >> Installing

Charge Air Cooler Housing, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals